• September 23. 2021

Nowadays, the rapid development of data services has led to an increasing speed of IP network convergence, so network expansion is very important. In the construction of metropolitan area networks, there is a widespread problem of optical fiber shortage. Because metro expansion requires less channel numbers than trunk systems, and the distance is relatively short, optical amplification is not requ...

• September 25. 2021

DWDM is a dense wavelength division technology. This technology multiplexes the tight spectral spacing of a single optical fiber carrier in a designated optical fiber in order to utilize the achievable transmission performance. This technical solution is used to increase the bandwidth of the existing laser technology on the optical fiber backbone network. The following ETU-LINK will introduce 10G ...

• September 28. 2021

With the gradual improvement of living standards, the concept of networked and intelligent buildings is no longer unfamiliar to everyone. In intelligent buildings, we can not only exchange data information quickly, control lights and adjust air conditioning through the network system, but also build intelligent scenes such as network monitoring systems and intelligent parking systems. In order to ...

• September 30. 2021

In this article, ETU-LINK will introduce the application of optical modules in the data center computer room. As we all know, the construction of the data center computer room is a system project. It consists of the following parts: the host room (including network switches, server group, storage, data input, output wiring, communication area and network monitoring terminal, etc.), basic work...

• October 09. 2021

As an important part of the optical network transmission, the optical fiber module functions as a photoelectric conversion, so that the signal can be transmitted in the optical fiber. So, do you know how to distinguish whether an optical fiber module is single-mode or multi-mode? Next, ETU-LINK will teach you a few ways to distinguish between multi-mode fiber modules and single-mode fiber modules....

• October 12. 2021

The Internet cafe network system needs to have a high bandwidth and support a large amount of data transmission. Therefore, Internet cafes have higher requirements for network hardware. When designing the Internet cafe network, it is necessary to ensure a high-quality network transmission speed, and also consider future network upgrades and maintenance. Next, ETU-LINK will introduce network equipm...

• October 16. 2021

SAN refers to the regional storage network, which needs to be connected by optical fiber, and the operation mode of the SAN mainly depends on the hardware. The structure of the SAN allows any server to connect to any storage array so that the server can directly access the data it needs no matter where it is located. Due to the optical fiber interface, the SAN also has a higher bandwidth. The SAN ...

• October 19. 2021

The Fibre Channel switch originated from the Fibre Channel protocol. On the fourth layer of the Fibre Channel protocol, the Fibre Channel-based SCSI protocol for storage, the IP protocol for the network, and the virtual interface (VI) protocol for clusters mapped to the network architecture are established. Fibre Channel switches provide Fibre Channel switching for high-bandwidth and low-latency d...